Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

post simulation on synopsys

Thread starter arkeint
Start date Jul 14, 2013

Status: Not open for further replies.

Jul 14, 2013

#1

A

arkeint

Newbie level 6

Newbie level 6

hello everyone

how do you do post simulations in synopsys?

Jul 14, 2013

#2

R

Rohitchampion

Member level 5

Member level 5

Are you using synopsys TCAD? and what do you mean by post simulation?

Jul 14, 2013

#3

A

arkeint

Newbie level 6

Newbie level 6

i suppose i'm using synopsys TCAD, simulating the layout's output waveform after doing LPE.

Status: Not open for further replies.

Similar threads

E
Post simulation mismatch for the Gm/C filter
- Started by elonjia
- Sep 29, 2024
- Replies: 1
Analog Integrated Circuit (IC) Design, Layout and more
Slew rate simulation of a discrete Op amp on Ltspice
- Started by PorDeseign00
- Jun 27, 2024
- Replies: 39
Analog Integrated Circuit (IC) Design, Layout and more
T
Simulation of opamps in Cadence
- Started by theguardian2001
- Oct 24, 2024
- Replies: 12
Analog Integrated Circuit (IC) Design, Layout and more
O
ADS Schematic and EM Simulation S11 result Problem
- Started by oops1180
- Jul 15, 2024
- Replies: 0
Analog Integrated Circuit (IC) Design, Layout and more
N
Calibre Pex Compilation Error PXR12 on line 270
- Started by Nilani
- Dec 4, 2024
- Replies: 3
Analog Integrated Circuit (IC) Design, Layout and more

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.

Accept Learn more…

Top