Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Post-processing filter in Blind signal separation

Status
Not open for further replies.
A

aliofds

Newbie level 3
Joined
May 25, 2008
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,296
Dears

I wrote a feed-forward BSS program to perform signal separation but i have a problem with releasing the Post-processing filter which his equation is w=1/(1-(w1(z)*w2(z)) using matLab

Note : I had the vaule of W1& W2 as a matrix using My algorithm
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top