Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Position of feedback loop injection resistor for SMPS?

Status
Not open for further replies.
T

treez

Guest
Newbie level 1
Hello,
In the below schematic (LTspice sim also attached) is R7 a good place for test signal injection for measurement of the feedback loop gain and phase margins (bode plots) with a frequency analyser (eg AP300 by Ridley)?
 

Attachments

  • Flyback _TL431_bias_type3.pdf
    19 KB · Views: 69
  • Flyback _TL431_bias_type3.txt
    9.5 KB · Views: 53

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top