Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

please help me for design a Op-Amp

Status
Not open for further replies.
A

arash2888

Newbie level 1
Joined
May 24, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
please help me for design an Op-Amp

I want design an Op-Amp by following specification.
please help me.

- Fully Differential
- VDD=1.8 V Single supply
- Differential Output Swing = 2.5 V p-p
- Low Frequency Gain > 70 dB
- Settling time to within 0.01% of the final value in less than 10 ns with a feedback factor of 0.5 and a load of 5pf with a 1-V differential swing step
- Power as minimum as possible (Less than 20mW)
 
Last edited:

Re: please help me for design an Op-Amp

Hi arash2888,

Please refer CMOS analog book by Razavi or Gray and Meyer or alan & hollberg.

These will be a good starting point or refer the tutorial paper on op-amp design by paul gray.

If this post was helpful pls click the helped me and help me

thx
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top