[SOLVED] Place ground in orCAD capture

Status
Not open for further replies.
H

Haier

Junior Member level 2
Joined
Oct 19, 2012
Messages
20
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,414
When I place GND in capture, it appears two libraries on the "place ground" dialog block which are" CAPSYM" and "Design Cache".
I have some questions as below:
1. CAPSYM: what's the difference between GND & GND_POWER ? how to use them?
2. Design Cache: why are there more than 5 GND in the cache while I just used 1 ?
 

Both are same.it refer to GND.If you want yo have two nets in design then use two different symbols otherwise use only one...

Right click on design cache and select cleacup cache..
 
Reactions: Haier

    H

    Haier

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…