Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
A have to design a PIFA in ADS and I don't know how to make 2 bending lines,this layout need to be in 3D.I've study the manual ,but I can't find anything about it.
Thanks for help.
We can do simulation for this model in ADS too.(as there are no multiple substrates in z direction).
Will you share the design so far modeled to pks95411@yahoo.com. I will simulate it and send back to you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.