Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Pick and place file generation in Altium for Panelized boards

Status
Not open for further replies.

Oveis.Gharan

Full Member level 4
Joined
Oct 21, 2006
Messages
197
Helped
34
Reputation
68
Reaction score
25
Trophy points
1,308
Location
Iran
Activity points
2,502
Dear All

Salaam

I have a PCB file that contains to panelized boards. One of them is placed in mirrored. I fabricated this board in this situation and want to place the panel in the Pick and place machine. I tried to get pick and place file for the panel from the Altium but there is a problem. Altium reports the part on the layer which was in the single boards and doesn't consider the mirrored style which the board is placed in the panel.

Could someone tell me how could i get the correct pick and place file from the Altium for the panel which contains some mirrored boards?

With Regards
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top