Hayee
Member level 2
Hi
I am using pic18f46k22 and using ADC module of it. Was reading the registers required for setup and stuck on one register.
ADCON1 bit 7 says its TRIGSEL bit
TRIGSEL: Special Trigger Select bit
1 = Selects the special trigger from CTMU
0 = Selects the special trigger from CCP5
is it necessary to select any of these to trigger the ADC conversion.
What If I don't want to use Special Trigger?
Thanks
I am using pic18f46k22 and using ADC module of it. Was reading the registers required for setup and stuck on one register.
ADCON1 bit 7 says its TRIGSEL bit
TRIGSEL: Special Trigger Select bit
1 = Selects the special trigger from CTMU
0 = Selects the special trigger from CCP5
is it necessary to select any of these to trigger the ADC conversion.
What If I don't want to use Special Trigger?
Thanks