pncneves
Newbie level 1
pic18f4431 pwm
Hi,
I´m using a pic18ff4431 and follwing an900 to make a controler for an ACIM. I've programed it with Microchip's firmware to open loop operation. The problem is that i can't get any output in the PWM's. Did anyone worked with this application note to do this? maybe there's some pin that should be connected to gnd or 5v?
I used the schematic provided in the application note.
Thanks for your time.
Hi,
I´m using a pic18ff4431 and follwing an900 to make a controler for an ACIM. I've programed it with Microchip's firmware to open loop operation. The problem is that i can't get any output in the PWM's. Did anyone worked with this application note to do this? maybe there's some pin that should be connected to gnd or 5v?
I used the schematic provided in the application note.
Thanks for your time.