PIC Basic Pro_serout serin problem

[zmanultra]

HI every one

iv got this problem with my routine, or somthing, it dosen't seem to work
this is what happens


------------------------------------------------
SO var PortB.7
BAUD CON 84 '9600 baud, no parity, true, always driven

MAIN:
SEROUT2 SO,BAUD,["HELLO WORLD"]
PAUSE 1000
GOTO MAIN

END
----------------------------------------------------
and when i seen the out put from the uart i get all these weird symboles, i dont understand Y

 

[PredAlien]

hmmmm

What frequency are you using for the clock?... Have you told PBP that you are using that frequency? Therefore when you do a SEROUT at 9600 baud, is the figure that you have given PBP for timing the speed valid? By default, PBP assumes 4MHz unless you tell it otherwise... and 4MHz isn't an option with that xtal selection on your board. What you have is a fine example of invalid baudrate.

 

[platonas]

Also check if you need TRUE or INVERTED mode.