Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pcb track width needed for three phase inverter circuit ....

Status
Not open for further replies.
R

Rinson

Newbie level 6
Joined
Apr 20, 2011
Messages
12
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,370
Hi. I am trying to make an inverter circuit. The thickness of copper on my pcb is 35 microns (.035 mm).. to carry a current of 12 A how much should be the track width.. The base material for the pcb board is glass epoxy .. any precautions to be taken for this current level ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top