Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PCB standard drill tools

Status
Not open for further replies.
G

gorkin

Advanced Member level 1
Joined
Feb 27, 2002
Messages
422
Helped
13
Reputation
26
Reaction score
5
Trophy points
1,298
Location
brazil
Activity points
3,375
Hi guyes!
What the standard drill tools used today?

Thanks, Gorkin.
 

Hi,

I don't know if there's a de facto standard that I don't know about, but I found out that different manufacturers uses different standard drill sizes.

You probably should contact your PCB manufacturer...

cyberblak
 

Seems, that for metric drill zise was in step of 0.1(mm).
 

we use 0.025mm, or 1mil step for holes above 0.2mm. for holes under 0.2mm laser must be applied, step should be continuously

mike
www.ezpcb.com
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top