power-twq
Full Member level 6
In my company, We usually use orcad to draw schematic and
generate netlist, then we use PADS to draw pcb, we feel this
combination is very well, each software has its native merit.
best regards
generate netlist, then we use PADS to draw pcb, we feel this
combination is very well, each software has its native merit.
best regards
suryakant said:Hi all,
which PCB design software i should prefer of the following:
P*otel, orcad, allegro or PADS.
EMI/EMC, high speed design and new component libraries availibilty are my issues of concern
Thanx.