Hi all,
I am designing a circuit board for a batch of 10000 boards, I have a few questions about good practices in PCB design, mostly pertaining to reliability and manufacturability. It would be really helpful if you could give me advice or direct me to any resources .
The first 3 are related to via's and PCB design :
- How reliable are via's , from a manufacturing standpoint do you end up with a lot of failed via's or are they generally reliable ?
- On the same note if you can route a short trace with a via and a longer trace without one, which one should be preferred ?
- i have a via as shown in the picture below, is that a good practice to have a junction at a via?