edaedaeda
Full Member level 4
PCAD symbol trouble
Having trouble with an existing pcad schematic.
I am trying to simply change the pin name on an existing component.
What I would like to do is save this part from the schematic into a library so that I can edit it.
This 132 pin part was built (by an unknown designer) with each pin having its own body.>>
looks something like an off page connector with pin numbers.
Is there a way to get this segemented part back to the library?
Thanks much
edaedaeda
Having trouble with an existing pcad schematic.
I am trying to simply change the pin name on an existing component.
What I would like to do is save this part from the schematic into a library so that I can edit it.
This 132 pin part was built (by an unknown designer) with each pin having its own body.>>
looks something like an off page connector with pin numbers.
Is there a way to get this segemented part back to the library?
Thanks much
edaedaeda