Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Patch antenna transmission line model

Status
Not open for further replies.
V

vfurlan

Full Member level 2
Full Member level 2
Joined
Mar 27, 2006
Messages
133
Helped
10
Reputation
20
Reaction score
2
Trophy points
1,298
Location
Slovenia
Activity points
2,185
Hi everybody.
I need an advice how to make a transmission line model for a irregular shaped patch antenna. Antenna I'm talking about is on the picture below. It consists of three squares. One “main” square and two smaller squares attached to it. How can I do it? Any ideas?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top