Re: pads2007, errors occured during split/mixed plane genera
When I say view, I mean literally, in a viewer (CAM 350, ViewMate, GC Preview, GerbMagic or whatever - there are tons of them out there, many are free). When you view them, they should look like the layers in your Layout editor.
When you look at individual layers, look for anomalies, incorrect CAM setups, errors during Gerber generation (almost unheard of in PADS, but you never know...), whatever.
You should ALWAYS review your Gerbers in a viewer before sending them off for fab, regardless of any DRC or other checks you may do while in the Layout editor. While you can expect many shops to review your Gerbers before fabbing the board, you should NEVER rely on them. And some do not review your data, what you send them is what you'll get back.
Added after 13 minutes:
inramazsola said:
Normal connectivity DRC founds no errors. Plane DRC gives this message "Connectivity checking has been done. Number of errors found -- 2"
And I didn't address this in my other answer...
Turn on only the plane in question (the DRC report will list the layer the error occurs on). If it's is on multiple layers, check one at a time.
Go to Setup - Display Colors (CTRL-ALT-C) and set the "Connection" color to white or yellow or something that will stand out to you.
Go to View - Nets. Turn off all nets (set "View Unroutes Details" to "None") except for the signal for the specific plane net you are checking, set it to "All Except Connected Plane Nets" and Ok out of the dialog.
Look at your plane layer both poured (PO or SPD) and not poured (PO again or SPO) to see if there are any rat nest lines running to anything (you may have to turn on a surface layer to see if a rat runs to an SMT pad without a via).
Rinse and repeat if you need to look at other layers.
I'd be willing to look at your board if you want (and are allowed to let me). I would guarantee non-disclosure. My email is in my profile.
Added after 10 minutes:
By the way, there is a very good Listserver just for PADS, see how to sign up here:
Click here for Link
There are quite a few very good and very experienced PADS users that subscribe to it and are always willing to help, many have been on there for years.
Just don't be intimidated by them (there are lots of in-jokes and stuff).