Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Pad Size for General Purpose PCB

Status
Not open for further replies.
C

CMOS

Advanced Member level 3
Joined
Jan 6, 2004
Messages
862
Helped
94
Reputation
186
Reaction score
50
Trophy points
1,308
Location
USA
Activity points
5,673
pad size

I would like to know what is the pad size, drill diameter and distance between pads used for gereral purpose PCB (vero board) with square pads.
 

I don't understand so well what you means...but I try to answer you.
At the beginning, we have used IPC-SM-782 "Surface Mount Design Land Pattern Standard" that you can find on www.ipc.org, and now we have "fix\adapt" the component pads whit the productive process.

MKBS
 

In vero boards the standard grid is 0.1" (≈2.54mm).
The gap between pads can be between 0.5 to 0.8mm and the pad will have 1.8-2.0mm.
Drill size can be anything between 0.85 and 1.0mm..
Regards,
IanP
 

Thanks IanP. Thats what I was looking for. Actually I want to make a PCB with some prototyping area but didn't knew what pad size is used for standard prototyping PCBs available.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top