solofrain
Junior Member level 1
Forgive me for using this antique:bang:
I'm trying to customize a pad
**broken link removed**
What I did is simply placing a rectangle pad and a round pad together
**broken link removed**.
In PCB editor, it appears to be
**broken link removed**.
It looks the rectangle pad is partially covered by the top solder. Will this be a problem in production? Will I finally get a good one (1st pic) or a bad one (3rd pic)?
If this method doesn't work properly, how can I create an irregular pad?
I'm trying to customize a pad
**broken link removed**
What I did is simply placing a rectangle pad and a round pad together
**broken link removed**.
In PCB editor, it appears to be
**broken link removed**.
It looks the rectangle pad is partially covered by the top solder. Will this be a problem in production? Will I finally get a good one (1st pic) or a bad one (3rd pic)?
If this method doesn't work properly, how can I create an irregular pad?