Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Output job Altium Desginer AD10

Status
Not open for further replies.

hemnath

Advanced Member level 3
Joined
Jun 24, 2012
Messages
700
Helped
61
Reputation
120
Reaction score
57
Trophy points
1,308
Location
Chennai
Activity points
6,566
Do the things.
1. open the PCB document. then File->Fabrication outputs->gerber files. Export the pcb file to camtastic file. It will open in new tab.
2. If you need pdf at scale 1:1, file->print->printer setup. If you have installed pdf creater. It will show in the list. Select from the drop-down list and save the pdf file.
3. If you want to print the pcb at 1:1 without converting to pdf... file->print. you can print to 1:1 scale

Best wishes :)
 

Vlad.

Full Member level 3
Joined
Jun 4, 2012
Messages
179
Helped
3
Reputation
6
Reaction score
4
Trophy points
1,298
Location
Bucharest/Romania
Activity points
2,567
Hello, I konow that, is verry good, but i can`t generatet in mirror for top layers. Now I pdf creator, I think this is only way to make pcb 1:1 no?
 

hemnath

Advanced Member level 3
Joined
Jun 24, 2012
Messages
700
Helped
61
Reputation
120
Reaction score
57
Trophy points
1,308
Location
Chennai
Activity points
6,566
Yes i used to print the pcb at scale 1:1 using pdf creator. if you want to mirror the top layer, While you are exporting to gerber, you can see the option. File->fabrication output. It will open a window "Gerber setup". In this window, you can see the tab "Layers". There you can mirror the layers whatever layers you like to do.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top