enrico
Member level 3
Dear all,
Can someone help me with the attached design made with AWR Microwave Office version 10 ?
I designed an oscillator in MWO software, so I first checked the circuit through a linear oscillator analysis (OSCTEST), by looking the loop gain and phase shift, then afterwards connecting the OSCAPROBE. Apparently the circuit is set to oscillate around 706 MHz, but I get an error saying "oscillator analysis terminated due to the maximum number of cycles, simulation failed".
Any help is appreciated. Thanks.
Can someone help me with the attached design made with AWR Microwave Office version 10 ?
I designed an oscillator in MWO software, so I first checked the circuit through a linear oscillator analysis (OSCTEST), by looking the loop gain and phase shift, then afterwards connecting the OSCAPROBE. Apparently the circuit is set to oscillate around 706 MHz, but I get an error saying "oscillator analysis terminated due to the maximum number of cycles, simulation failed".
Any help is appreciated. Thanks.