quattro44
Newbie level 4
I have been using OrCAD 16.0 for a while now and have gotten used to it. Recently, I installed OrCAD 16.2 to my machine. And as soon as I opened the Pad Designer to make a new padstack, I noticed little differences between the two versions. The selection for Type (Through, Blind/Buried, Single) and Internal Layers (Fixed, Optional) that are available in version 16.0 are gone in version 16.2 and replaced with the summary of the hole information.
Below is a picture of the Pad Designer in version 16.0 (left) and Pad Designer in version 16.2 (right).
I want to know how i can go about setting the hole type and the internal layers now that those options are not available. Or is there a way to make those options available?
Below is a picture of the Pad Designer in version 16.0 (left) and Pad Designer in version 16.2 (right).
I want to know how i can go about setting the hole type and the internal layers now that those options are not available. Or is there a way to make those options available?