Tehell
Newbie level 2
Hello fellows,
I found very strange problem, which I don't know how to fix.
After I made schematic in Orcad Capture I have imported netlist to Layout and then made PCB.
Unfortunatelly now i noticed there is completely no drills at the board. Maybe this is somehow connected that I have choosen only 2 layers top and bottom at the beginning of the work.
Do You have any clues how to solve it?
Screen attached.
Thank You in advance, Teh.
I found very strange problem, which I don't know how to fix.
After I made schematic in Orcad Capture I have imported netlist to Layout and then made PCB.
Unfortunatelly now i noticed there is completely no drills at the board. Maybe this is somehow connected that I have choosen only 2 layers top and bottom at the beginning of the work.
Do You have any clues how to solve it?
Screen attached.
Thank You in advance, Teh.