paulojfonseca
Newbie level 2
orcad capture 10.3
Hi to everyone,
I recently changed the version of my Orcad Capture software from 10.3 to 15.7.
When i open in Capture 15.7 drawings made in 10.3 version, i notice that the parts are not anymore alligned with the grid, there is a bit of offset in X and/ or Y direction. This is a bit anoying when i'm editing the schematics, because the pointer is allways snaping to the grid.
Is there any configuration i need to change in Capture 15.7 to solve this problem?
Regards
Paulo
Hi to everyone,
I recently changed the version of my Orcad Capture software from 10.3 to 15.7.
When i open in Capture 15.7 drawings made in 10.3 version, i notice that the parts are not anymore alligned with the grid, there is a bit of offset in X and/ or Y direction. This is a bit anoying when i'm editing the schematics, because the pointer is allways snaping to the grid.
Is there any configuration i need to change in Capture 15.7 to solve this problem?
Regards
Paulo