Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Opinions about STM ARM products

Status
Not open for further replies.

tjalps

Full Member level 5
Joined
May 28, 2001
Messages
240
Helped
6
Reputation
12
Reaction score
3
Trophy points
1,298
Location
SLOVENIA
Activity points
1,994
stm arm

Hello!

I'd like to now your opinion about STM ARM products on suport tools, technical suport, problems...

Regards!
 

stm arm

Been using the device for about a year, very impressed.
What is good is the new 73x range - single 5v supply, good peripherals and dma !!

Support no better or worse than others i have used.

Regards
NTfreak
 

Re: STM ARM

Good. I have seen that they have realy enough peripherials and that is what I like.

I'd like to now more about C compilers, emulation, JTAG tools, what IDE are you using?



Best regards!
 

Re: STM ARM

Using the free ide from Anglia - includes gcc/insight/str71 libs etc.
www.anglia.com/columbus - link to software at botton of page.

Also got a copy of rowley crossstudio which fully supports this device.

Regards
NTFreak
 

    tjalps

    Points: 2
    Helpful Answer Positive Rating
Re: STM ARM

Hi,
Do you know about any problem about STR71x or STR73x,especially for CAN controller ? there so many hardware bugs in LPC2XXX,TMS470,MAC7100 :cry:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top