Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

open cartridge of laser printer

Status
Not open for further replies.

makri

Full Member level 2
Joined
Jan 1, 2004
Messages
128
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
India, Kerala
Activity points
812
How can i open safely the laser printer cartridge?? Any one have the mechanical diagram of Hp cartridges??
 

I think you'll have to disassemble the first one for experience (make some photos). After that you can handle the following ones with success.

Regards from Germany
 

study it, and likely you have to remove some stainless locking pin -- note they are just pin, pull them out by piler. but i am finding inkjet is getting a better option as i can do double side smoothly, unlikely the forever sticking problem using laser.
 

Actually it's easy , you just have to be careful how you hold it so you don't spill tonner all over.Hold the cartridge with the tonner compartment down.You have to remove 2 safety pins then the drum unit and the transfer cylinder.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top