First you need to have simulink installed in Matlab, otherwise it will not work. Once you have installed, you can open the file and you will see blocks where you can changes its parameters. You can run and see the output response and so on.
You can actually do all this in Cadence by using Verilog-A and ModelWriter to model Op-amp with all its parameters and use spectre to do DC, AC, ... simulation.
Thanks xuel. It seems that for differential input and output you simply have two copies of it and connect them to common ground. How would you go about modeling differential input with single ended output?
Thanks xuel. It seems that for differential input and output you simply have two copies of it and connect them to common ground. How would you go about modeling differential input with single ended output?
I think just connect the negtive input of the first vcvs source in my figure to your negetive input pin can realize a differential input single ended output amp