It is possible to use OPAMP as a single supply and get negative output from it.
In my circuit I am giving a 7-15V supply and want to negative output.
Please guide.
An op-amp can't produce an output voltage outside the range you supply it with. You might be able to create a virtual ground using an op-amp, where the output pin is used as ground and the supply sits either side of it but there are limitations to the current it could provide and the combined positive and negative sides will not be greater than the supply.
Since an Opamp has no GND pin .. it always is "single supplied".
But even manufacturers and datasheets refer to "single supplied" when the negative supply is connected to GND.
Now to your question:
--> The (driven) output voltage of an Opamp is always within it's supply rails.
Opamps with output going close (within millivolts) to the supply rails are called "rail to rail output"
But every Opamp that is specified for 5V supply may be supplied with:
* 0V / 5V
* 5V / 10V
* -5V / 0V
* -100V / -95V
* 100V / 105V
Just the difference counts.
And all inputs and outputs refer to these supply rails.
The MAX44267 precision, low-noise, low-drift dual operational amplifier offers true-zero output that allows the output to cross zero maximizing the dynamic range of an ADC and increasing resolution. In addition, the input common-mode range extends fro
www.maximintegrated.com
Keep in mind you can always use a switcher or a charge pump IC to gen
negative V's to run split supply designs....The above part just happens to have
that built into it with its two opamps internal as well.