Your schematic is now correct but I'm a little concerned about the signal you are feeding into it and as mentioned earlier, the DC effect it may be having. The two 5K resistors will set the '+' input at half potential, which is what you want but if the signal you are connecting into it also has a DC component, it will upset the level. Try feeding the input signal through another capacitor so it can't influence the DC conditions.
Note that as I pointed out before, the NE5532 has a pair of head-to-tail diodes across it's input pins so the maximum voltage you can feed into it maybe limited. It is really a device intended for amplifying very low level signals with low noise rather than a large signal. Don't forget that with restricted output voltage swing, depending on the gain you have set, even a small input might cause the output to clip badly.
You are on the right track though!
Brian.