Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

one phase PWM to 3 phase PWM

Status
Not open for further replies.

david753

Full Member level 1
Joined
Jan 9, 2005
Messages
96
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
856
I have a NI-PCI-7344 Motion control card.
There are 2 PWM output.
But, I would like to drive a brushless 3 phase motor.
How can I design a system that converts one PWM to 3 phase PWM for brushless motor?
Can I use TMS320F2812 DSP chip?
Could you tell me some advice in detailed?

Thank you very much.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top