Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

On off switch to use with 5 second power pulse remote control.

Status
Not open for further replies.

laxray

Newbie level 1
Joined
Jan 28, 2012
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,288
I have a 6 volt motorized duck with spinning wings (see MOJO duck). I also purchased a 300 ft remote for a deer feeder. I was hoping to wire the remote into the duck and be able to turn it on and off. The remote supplies a 5 second pulse of electricity to power a feeder for 5 seconds. Is there any way to make that pulse turn the duck on. then with the next 5 second pulse (when you hit the remote again) turn the duck off. Any suggestions would b great.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top