Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

not showing the etch length only unrouted length is showing by allegro16.2

Status
Not open for further replies.

matt2011

Newbie level 4
Newbie level 4
Joined
Mar 7, 2011
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,325
I am using allegro16.2 for the pcb design of my digital board.After routing I have gone to constraint manager to get the total etch length but when i analyze the digital net ,it is showing only the unrouted net length ,it is not showing the total etch length.sobody pls help!!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top