Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Noise Filter for Hall sensor output

smijesh

Advanced Member level 1
Advanced Member level 1
Joined
Sep 20, 2013
Messages
417
Helped
163
Reputation
326
Reaction score
163
Trophy points
1,323
Activity points
4,079
How to design a noise filter of a Hall sensor output of a BLDC motor, Hall output time period will vary from 10ms to 150ms based on the speed of the motor
 

Attachments

  • Hall Noise.jpg
    Hall Noise.jpg
    30.5 KB · Views: 37
Hi,

the diagram wihtout timing is useless.
Asking for a solution .. while giving no goal .. I call it useless, too.

--> Show input signal including timing information and a sketch of the according expected output signal.
Then we may be able to find a solution.

Klaus
 
Your scope trace looks like it could be either a Hall switch or Hall sensor. Do you wish to ignore the two short pulses appearing like bookends to each long pulse? You might move the sensor further away to reduce its range of response. Maybe you can find a sweet spot where you get the right-shaped pulses at all motor speeds.
 

LaTeX Commands Quick-Menu:

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top