ColdWave
Newbie level 3
Hello, i'm new to the FPGA world as well on the forum. I kindly ask you guys to give me some assistance with a project. I've attached a picture to make the task easier to understand. I have to light up some of the LED segments on the board (those are like walls, can't go through them, just like a maze) and a special one, used for movement (this one has to blink while moving). The movement is done by the 4 pushbutton switches (assigned up, down, left, right) and I have to arrive at the last segment on the right (bottom). Once there, all segments have to blink, and use the reset switch to start all over again.
Any help would be highly appreciated! Thank you.
Any help would be highly appreciated! Thank you.