Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

need information about hsp50216

Status
Not open for further replies.

vonzhaoqun

Junior Member level 2
Joined
Jan 17, 2003
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
china
Activity points
144
:( i am using hsp50216,but the datasheet ,fn4557.pdf from intersil is to simple,i cann't find any information about the uP mode Pin,so that i do not know how to interface my tms320vc5416 to the hsp50216,can any one help me?thank u very mch.
 

drwho78

Full Member level 3
Joined
Dec 31, 1999
Messages
163
Helped
10
Reputation
20
Reaction score
5
Trophy points
1,298
Activity points
1,143
The uP Mode affects two other pins, the WR*,DSTRB* and RD*, RD/WR*. When uP Mode pin is low, the pins becomes WR* and RD*. This is for sysems that use seperate Read and Write lines. If the uP Mode pin is high, you will use RD/WR* for Reads and Writes, but DSTRB* must be asserted to get data in or out. To interface with the tms320vc5416, you will set uP mode = 1.
 

vonzhaoqun

Junior Member level 2
Joined
Jan 17, 2003
Messages
24
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
china
Activity points
144
drwho78:
thank u very much. can u tell me where can i find these information?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top