Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can not directly draw a schematic in simulink - for that you need SimScape.
But you can represent the differential equation of the circuit.
Start from the higher order derivative, in this case di/dt from the inductor equation.
Then integrate it in order to get i.
Then "close the loop" using adders, gain block, and so on until you get di/dt from the other elements.
It is complicated to do with only the basic Simulink libraries.
Check in the Simulink library browser if you have the Simscape libraries installed.
Under "foundation library - electrical" you should find everything you need.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
