Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[PIC] Need help to write a program to control AD9834 DDS using PIC16F877A micro controller

Status
Not open for further replies.

syams86

Newbie level 1
Joined
Jan 29, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Hi,
I need help to write a program to control Analog Devices AD9834 DDS using a PIC16F877A micro controller. DDS chip is connected in PORTB of PIC16F877A uC. 3-Wire (SCK-->RB0,SDI-->RB1,FSYNC-->RB2) software SPI communication is used. The RESET Pin of DDS Chip is connected in RB3. FSELECT and PSELECT pin of DDS chip is grounded. I uses 20MHz master clock to generate 19kHz sinewave from DDS chip. Please provide a pseudo code or C code to program DDS chip connected to PIC uC. Thanks in advance.
 

Hasan Abdr

Newbie level 1
Joined
Apr 15, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
4
Hey friend , Im facing the same problem as urs , which is writing the C code !! Please let me know if ur able to fix that and had your code done !
 
Last edited by a moderator:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top