Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
for two things if its connected to the Vcc and Gnd pins then its for filtering out any ripples on the power supply. and if it is between the Xtal pins and ground then its for burden capacitance to start the pierce oscillator inside the microcontroller
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
