Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
This error has to do with the pin allocations, if you double click a part and unlock its pins, then double click the pin that is causing the error you will be able to see the electrical type. This should be set corectly to suit your component / design. Most of the time its a non error, but it depends on your design.
Another anoying thing that causes it is placing terminating resistors in line with a pin thats set up as an output. The net from the terminating resistor to the input gets flagged as not having a driving source
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
