Mutli Booting FPGA, ICAP through BPI Flash

[akhil.592]

I have to multiboot FPGA i.e; Loading 2 and more bit files in Prom and through an external switch, i have to select the respective modulation(In this case). Does any one has Idea of how to program... and also how to give a signal to the ICAP module and what is the booting address of it...??

 

[axcdd]

what vendor FPGA are you using ?

 

[akhil.592]

Xilinx Virtex-6

 

[ads-ee]

If you haven't you should start by reading the following documentation.
UG360 - Virtex-6 FPGA Configuration User Guide
UG702 - Partial Reconfiguration User Guide

The first describes all the configuration options of the V6 and the second (partial reconfiguration) might be more suitable than reloading the entire design if all you want to do is change the modulation code.

 

[akhil.592]

I have 4 Bit files-- of 4 Different Modulation, I want to load them at runtime, one after the other, Is it possible to load using partial Configuration(I doubt it) using the specifications metioned.