neofrkh
Junior Member level 1
multisim switch
I designed a circuit using Time Delay Switch "TD_SW1" to switch voltage source from 12V to 6V for 0.5 sec, and get graph of current through a resistor from 0 to 2 sec. But while doing Analysis, the switch did not work.
Whole graph was plotted only considering 12V source.
So
How to plot this current graph using switch?
I designed a circuit using Time Delay Switch "TD_SW1" to switch voltage source from 12V to 6V for 0.5 sec, and get graph of current through a resistor from 0 to 2 sec. But while doing Analysis, the switch did not work.
Whole graph was plotted only considering 12V source.
So
How to plot this current graph using switch?