Hello,
First of all, Thank you for the response.
Currently, i'm going through literature study where i encounter with this Select command. From the literature where it mention
MemBank specifies how a Tag applies Mask. If MemBank=002 then the Tag searches for at least one file
whose FileType matches Mask. If MemBank=012, 102, 112 then a Tag applies Mask to the EPC memory
bank, TID memory bank, or File_0, respectively. A Select specifies a single FileType or memory bank.
Successive Selects may apply to different file types and/or memory banks.
• Pointer specifies a starting bit address for the Mask comparison. Pointer uses EBV formatting (see Annex
A) and bit (not word) addressing. If MemBank=002 then an Interrogator shall set Pointer to 00h; if a Tag
receives a Select with MemBank=002 and a nonzero Pointer value then it shall ignore the Select.
• Length specifies the length of Mask. Length is 8 bits, allowing Masks from 0 to 255 bits in length. If Mem-
Bank=002 then an Interrogator shall set Length=000010002; if a Tag receives a Select with MemBank=002
and Length<>000010002 then it shall ignore the Select.
If we choose MemBank="01" how we should write code in VHDL for matching case?
If anyone can help me on this, that would me really helpful.
Thank you,
suha4744