Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am using SPROCESS in Sentaurus TCAD, I am unable to set a contact for gate terminal, I am attaching my code, SVISUAL and error snap shorts by email to anyone . can you give me any suggestions regarding this issue.
Re: Problem with contact setting in TCAD Sentaurus SPROCESS
First, these are warnings, not error messages (meaning - may not be critical).
Second, normally, "contacts" are defined for device simulation, not for process simulation - and from your log messages, it looks like you are doing a process simulation.
Did you specify gate.1 and gate.2 regions / contacts in your input deck?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
