Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[MOVED] Matlab Co simulation

Status
Not open for further replies.

Milruwan

Member level 1
Member level 1
Joined
Jan 20, 2013
Messages
35
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,546
out.jpg
I simulate a matlab co simulation project using modelsim. I created a fixed point filter using fdatool and co simulate it. I successfully observed the output from the modelsim but the matlab scope gives a blank output. what is the reason? How can I observe the output using scope?
 

Re: Matlab Co simulation

Yes, scope scaling is adjusted according to the time scale, and also I auto scale the scope but the output of the scope is blank but modelsim gives an output as shown in the picture.
 

Re: Matlab Co simulation

I only observe the output waveforms from modelsim output but can't observe the output from matlab scope. What is the reason?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top