Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[moved] How to define integration line for this antenna?

Status
Not open for further replies.

Apple153

Newbie level 4
Joined
Oct 24, 2017
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
38
Hi

I would like to know how should I define the integration line for this kind of antenna ?
Is it ok to define the integration line as in the file "antenna with integration line.jpg" ( red line)? If not, then the arrow should be pointing in which way?

antenna.png
antenna with integration line.png



Thank you
 

Apple153

Newbie level 4
Joined
Oct 24, 2017
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
38
I forgot to mention but I am using HFSS software. I would like to know in which direction the arrow (integration line) should be pointing?
 

sandeepkiranv

Advanced Member level 4
Joined
Dec 26, 2015
Messages
102
Helped
10
Reputation
20
Reaction score
8
Trophy points
18
Activity points
600
i think your using lumped port excitation, in that case, the interation line is taken from the top conductor to the bottom conductor ( in this case your feed line)
 

Apple153

Newbie level 4
Joined
Oct 24, 2017
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
38
i think your using lumped port excitation, in that case, the interation line is taken from the top conductor to the bottom conductor ( in this case your feed line)

Do you mean like in this attached picture ?

If I try to define like that, it tells me ¨Lines can only be created on select surfaces¨
It's like my integration line must be inside the excitation plane ( must be drawn inside that rectangle ).
Whenever I click outside of that rectangle it says ¨Lines can only be created on select surfaces¨
Does anyone know why and how I could solve this?

integration line.png
 

volker@muehlhaus

Advanced Member level 5
Joined
Apr 11, 2014
Messages
2,661
Helped
1,008
Reputation
2,022
Reaction score
1,008
Trophy points
1,393
Activity points
17,075

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top