Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It's not clear what the gate resistor is, it looks like 1.1K to me, but I'm not sure; in fact, I can't really read anything on that schematic. That 1.1K would be inexplicably large, but shouldn't cause a static problem. It's also not clear what "1 Volt at low state" means. You mean when the MOSFET is on? (Low). Or when the Gate voltage is low? I think we need more information. What is the MOSFET? What is gate voltage (you might need about 10V to drive it fully on, depending on the device)?. What is your timing?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.