Mosfet gets short when powered

Status
Not open for further replies.

shoaib909

Newbie level 1
Joined
Sep 3, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
8
Dear guys i m trying to make a H-bridge by using Mosfet i m using irf9530 (p-channel) and irf510 (N-channel) mosfets without power there is no shorting between source and ground as i give the power they short and my irf9530 gets hot
https://www.bristolwatch.com/ele/h_bridge.htm i am using this circuit
 

You've probably wired something wrong.

But what do you mean "between source and ground"? The source of your n-channels ARE connected to ground; the sources of your p-channels are connected to power if you did it right. And you say "I am using this circuit", and then attached FIVE circuits. We are not mind readers, you know.
 

The circuit shown in the link is merely didactic.
We can´t see any protection circuit transistor (snubber).

Also, you did not inform the motor power.
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…