Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Monte Carlo Simulation in cadence!

Status
Not open for further replies.
R

rficdesigner

Member level 2
Joined
Jun 17, 2008
Messages
52
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Korea
Activity points
1,592
Dear all,

I would like to run Monte Carlo Simulation in ADE cadence! TSMC 035um
However when I run it showed this message: "mc1: Attempt to run Monte Carlo analysis with process and mismatch variations, but no variations were specified in statistics block."
I dont know exactly how to do simulation!

If you know, please guide me.

Thank alot.
 

hi,did u change the model library from cmostm to cmosmc ?i made that mistake before,just change the tm to mc.and try again..
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top