Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Monte Carlo IP2 simulation with Cadence QPSS+QPAC

Status
Not open for further replies.

Ian.Y.Jin

Newbie level 6
Joined
Mar 17, 2009
Messages
11
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Activity points
1,362
qpss plot

Hi,

I have a question related to Monte Carlo simulation for a mixer IP2 in Cadence using QPSS+QPAC.
For a single point simulation, I can have the IIP2/OIP2 result from "Direct Plot -> qpac -> IPN Curves"
after setting a few parameters. I don't know how to set up the corresponding expressions for the Monte
Carlo simulation.

Any one share some tips? Thanks.

Best Regards,
Y. Jin
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top