Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

MMC and LMC - explanation needed

Status
Not open for further replies.

prapan

Junior Member level 3
Joined
Jun 3, 2008
Messages
26
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,451
MMC and LMC

Can somebody explain the terms Maximum Material Condition and Least material Condition? I have read the definiton of these terms but am still confused!!!

How does MMC of a hole be when it has the smallest diameter and LMC of hole be when the diameter is largest ?
 

MMC and LMC

MMC is basically used when board is not densed
LMC is used when we are dealing with dense boards.

only difference is LMC require better fabrication and assembly setup .
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top